Code CR3600DPM Informações Técnicas descarregar pdf (Página 13)

10/29/2014

Page 13 of 72



12393 South Gateway Park Place Suite 600, Draper, UT 84020



(801) 495-2200



FAX (801) 495-0280

Causes the Reader to reset its internal date/timestamp to the specified time; data contains the

date and/or time in one of the following formats.

yyyy-mm-dd hh:mm:ss

yyyy-mm-dd hh:mm

hh:mm:ss

hh:mm

Note: the separators are optional; only digits are significant.

(The Reader will respond with d or e.)

Examples:

Set to midnight: @00:00

Set to Sept 1, 2005 11:52:02 PM: @2005-09-01 23:52:02

Notifies the Reader that the previously sent data were rejected for one of the following reasons:

 The packet was encrypted and the decryption failed.

 The Host (CodeXML

Modem) is locked to a different Reader.

The Reader should indicate to the user that the packet has been rejected; e.g., it may sound

error beeps. See related register 12F: notify-of-packet-rejection.

(The Reader will not respond to the Host.)

Apply a value to a register on the reader and save the value; data is in one of the following

formats:

(XXX)YYY where XXX is the register number and YYY is the setting value, both in ASCII hex. This

will change the value in the register and save it. For example C(26)64 will change the value of

/(XXX)YYY where XXX is the register number and YYY is the setting value, both in ASCII hex. This

will toggle the bits in YYY and then save the resulting value (see / command). For example

C/(1F7)40 will toggle bit 6 of register 1F7 and save this setting.

O(XXX)YYY where XXX is the register number and YYY is the setting value, both in ASCII hex. This

will set the bits in YYY (change those bits to 1s) for register XXX (see O command). For example

CO(1F7)40 will set bit 6 of register 1F7 high and save this setting.

Q(XXX)YYY where XXX is the register number and YYY is the setting value, both in ASCII hex. This

will clear the bits in YYY (change those bits to 0s) for register XXX (see Q command). For example

CQ(1F7)40 will clear bit 6 of register 1F7 and save this setting.

Note: The C command saves changes immediately and those settings will survive a reboot. It is

equivalent to issuing a P and =, then a W command. C(2B)0 is the same as these three

commands combined: P(2B)0, =(2B)0, W

(The Reader will respond with d or e.)

Note: Also see commands O, P, Q, /, =, W. See Section 8 for possible Reader settings.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 71 72

Comentários a estes Manuais

Sem comentários

Code CR3600DPM Informações Técnicas Página 13

Comentários a estes Manuais

Manuais e produtos relacionados com Leitores de códigos de barras Code CR3600DPM